Keeping a bidet in the bathroom is an inconvenience, but there are several ways to hide it. For one thing, you can turn it into another visually pleasing item. You can paint or polish a wooden box, for example. You can also custom design a wooden seat with a design of your choice. A custom wooden seat will be lighter than a bidet and will take up very little room in the bathroom.
Before installing a bidet, you should make sure the location is level. If you are installing it over an existing floor, you need to make sure it’s level. Once you’ve done this, you can start drilling holes for the bolts. Make sure you place the nuts at a reasonable height, but not so high that the decorative caps won’t snap into place. Also, make sure that the subfloor is stable, so you don’t run the risk of damaging the bidet’s base.
Bidets are similar to toilets, but are typically located next to the toilet. They are similar in design, and have an adjustable spigot to rinse your hands after using the toilet. Some people prefer to keep their bidets covered. The bidet’s water supply can bounce off of a public Bidet, which can be dirty.
Fortunately, there are many ways to cover up a bidet. While it’s important to remember that you can leave the cover on the bidet when not in use, it’s best to purchase a cover for your bidet before you start using it. It’s a good idea to check with the manufacturer of your bidet to see what they recommend for its use.
If you want to cover up a bidet, be aware that some bidets don’t have jets. These types use a faucet and fill the basin with water. Be sure to use soap to clean yourself and to dry thoroughly afterward. In addition, some bidets have a cloth towel nearby. While these options may not be practical for your bathroom, they are useful to keep close at hand when you need to dry your hands.
Once the bidet is installed, the next step is to remove the toilet seat. If your bidet is mechanically handled, the water jet should be placed in the middle of the bowl. This will prevent the jet from overheating sensitive areas. It may be necessary to hold the control for a while to keep the jet on. If you are in a hot climate, it might be best to start off with cold water before adjusting it to your toilet.
The bidet seat will come with a two-pronged branch valve. This valve divides the water supply into two separate lines, one for the toilet and one for the bidet. The branch valve connects to the existing water valve in the toilet tank. Be sure to place a rubber gasket in the water line valve to avoid leaks. The new hoses are connected to the branch valve with screws.